Installation
Installation really couldn't be simpler! The Daytona Tile Locking System snaps the tiles easily into place, making your job a dream. Below is a helpful installation guide for you to use.
Daytona Garage flooring Installation and Maintenance Guidelines
Installation Tips
1. TILE LOCKING SYSTEM
The locking system consists of a male peg and female loop. The male peg snaps into the female loop
holding the tiles together.
2. CORRECT TILE ALIGNMENT
All tiles on any given installation should ALWAYS HAVE THE FEMALE LOOPS GOING IN THE SAME
DIRECTION. CAUTION: If you inadvertently rotate a tile 90’ it will snap into place, but you will not be able to
complete the installation properly.
3. ASSEMBLY PROCEDURE
IMPORTANT: Begin the installation in the open end of the garage (where the car enters). Standing inside
the garage, looking out. Lay the first tile down with the peg sides to your right and away from you. Working
right to left, align the locks with the loops and snap them together using your foot or by lightly tapping them
together with a rubber mallet.
4. TRIMMING AROUND OBSTACLES
When trimming tile around shapes or obstacles, straight lines are easier to cut then circles or shapes.
Remember to allow for expansion and contraction of the floor. If the flooring comes in contact with an
immovable object it will tend to “bunch up” or “buckle.” Be sure to over trim by at least 1” to accommodate
for expansion and contraction.
5. DISASSEMBLY
Insert putty knife between male and female lock. Tilt knife away from male peg so that male lip unlocks and
lifts out.
Maintenance Guidelines
A regular cleaning regimen using a damp mop and mild cleanser will help keep your tiles looking new for years. The following guidelines must be followed to ensure that you get the most from your Sport Court® DaytonaTM garage flooring:
1. CLEAN SPILLS IMMEDIATELY
It is critical that spills are cleaned WHEN THEY OCCURE. Petroleum based chemicals such as motor
oil or gasoline can damage the tile if not cleaned as they happen. General household cleaners made to“cut” grease work well to separate grease or oil from tile.
2. PERIODIC MAINTENANCE
Soaps, mild detergents and citrus cleaners can be used with a damp mop for periodic cleaning. Sweep
the floor often to remove rocks and other debris that could scratch or damage the surface. Gum can be
removed by carefully using gum remover and putty knife.
3. DEEP CLEANING
In addition to regular cleaning, tiles may be removed in large sections and deep cleaned outside of the
garage with a power scrubber and cleanser
4. REMOVING A SINGLE TILE
If a single tile is damaged, it is possible to remove it using a
putty knife. Carefully slide the knife into the seam behind the
tile’s “lock” and disengage the lock system. Repeat this on
each of the locks going around the tile until it releases
completely and can be removed.
